Safe and civilized operation rules for shot blasting machine

A. Check "Shift Work Record".
B. Before starting the shot blasting machine, it is necessary to check the wear of protective plate, rubber curtain, roller and other wearing parts. If worn, please replace it in time.
C. Check the coordination of the moving parts and tighten the bolts in time.
D. Check whether sundries fall into the machine and remove them in time to prevent equipment failure caused by blocking each conveying link.
E. Check whether the lubrication of each part meets the requirements.
F. Before starting up, only when it is confirmed that there is no one inside the room and the access door is closed and reliable, can it be ready to start up. Before starting the machine, give a signal to the people near the machine to leave.
G. Follow the operation procedure correctly.

A. First, start the dust removal fan, check the operation and confirm normal operation before starting the shot blasting machine. Before starting the shot blasting machine, do not open the control valve of iron shot.
B. It is necessary to check the cleaning quality of steel frequently, and adjust the projectile projectile Angle and roller conveying speed if necessary
C. Observe the workpiece on the roller table at any time whether there is any deviation, skid should be eliminated in time.
D. Pay attention to whether the vibration and sound in the operation of the shot blasting device are normal, and the temperature rise of the bearing and motor. When there is any abnormality, stop the machine for inspection, troubleshoot or replace the blade.
E. When the shot blasting room is finished, the shot tube should be closed first and the air inlet should be stopped. Turn off the shot blasting motor and stop the fan.
F. If abnormal phenomenon occurs, stop the operation of the shot blasting machine immediately, check the cause and eliminate it in time.
G. Wet steel plate is strictly prohibited to enter the shot blasting room for shot blasting.

A. Cut off the power supply of the equipment and clean the sundries on the screen at the bottom of the separator.
B. Carry out daily maintenance.
C. Fill in the "shift record" and do a good job in the shift work of the shot blasting machine